Step 1: Import device in the builder called "Sharp Quattron TV IP and RS232 Control" when searching for Type=TV+Vendor=Sharp
Step 2: Setup as NETWORK GATEWAY in iRule app with port number the same as in the settings of TV.
Step 3: For proper IP control you need to disable power saving feature of the TV by following steps below.
-
1. Make sure TV is powered ON
-
2. Send RSPW2 command (one of the commands for device) Create a button with this command.
-
3. Wait 5 seconds
-
4. Then send Power On command
To test, send Power OFF then wait 10-15 seconds and then send Power ON. TV should turn on.
Please note that Sharp TVs allow only a single connection to their TCP/IP port which means only one instance of iRule can control this piece of equipment at any given time.
